Battery/Inverter Fuses

Fuse carriers for NH type fuses, suitable for protecting and isolating cables between the battery and inverter. Integrated handle enabling use as an isolator.

2 poles of the 3-pole carrier carrier can be used to fuse and isolate both positive and negative at the same time, all in the same device.

NH1 for DC currents up to 250A.

NH2 rated at 440VDC, 400A

Shrouds provide terminal protection.

NH1 & NH2 high capacity fuses rated at up to 600VDC suitable for protection of cables from batteries to inverters.

Double pole fused disconnectors. These protect the cables between batteries and inverters and allow easy isolation for installation or maintenance of the inverters.
Includes two pole 8A fuses for connection of other DC equipment.

Versions for use either with one inverter or clusters of three.

Supplied complete with two spare fuses.

160A for SI-6.0H ; 200A for SI-8.0H 

Double pole circuit breakers. These protect the DC cables between batteries and inverters against overcurrent and short-circuit and allow easy isolation for installation or maintenance of the inverters.

Rated for maximum charge/discharge voltage of 75V DC and max. short-circuit current may of 10kA.

Versions for use either with one inverter or clusters of three.

VT (voltage tap) version includes two pole 8A fuses for connection of other equipment.

Fuse holder for MEGA fuses.

Fuse holder for MEGA fuses with dovetail feature allowing interlocking multiple fuse holders on the busbar.

Five position bus bar takes up to five fuse holders with one M10 input connection and input current up to 500 A.

Victron MEGA fuses for protection between batteries and inverters.

32V versions for 12 & 24V systems.

58V versions for 48V systems

The Victron Lynx Distributor is a modular DC bus bar with locations for four DC fuses.

Each fuse's status is monitored and its condition indicated with a LED on the front.

Part of the modular Lynx distribution system.

Use with ANL Fuse Holder for many applications with 35-750 Amp loads

• 6,000 Amp Interrupt Rating for main DC circuit protection on large battery banks
• Silver-plated connector blades for corrosion resistance
• Visible indication of blown fuse condition

FB-ANL-1

• Accepts M8 ring terminals
• For use on systems up to 32 Volts DC
• Swing out design allows replacement of the fuse without removing fasteners
• Stainless steel studs provide resistance to corrosion and high torquing for excellent electrical contact
• Insert molded studs ensure secure fuse mounting
• Insulating cover satisfies ABYC/USCG requirements
• Cover breakouts allow wire access in any direction
• Fuse sold separately

VFB-ANL can be used up to 80 Volts but doesn't include cover