Collection: Wind & Sun

Suitable for mounting on battery room walls and doors, intended for lead acid batteries.

Ready-made cables for connecting batteries in series or parallel. Cables include two crimped terminal lugs with 8 mm diameter holes.

Systems with inverters larger than 1kW should use 50 mm² or larger battery interconnects, those with smaller inverters 35 mm² and systems where currents are always less than 30A, 25 mm². Cables are double insulated and can be supplied with colour coded heat shrink marking.

Used in systems incorporating energy storage systems (including batteries and inverter/chargers) with grid connected solar photovoltaic systems in a building. This should be fixed:
a) at the origin of the electrical installation;
b) at the metering position, if remote from the origin; and
c) at the consumer unit or distribution board to which the AC supply from the inverter is connected.

Used in systems incorporating energy storage systems (including batteries and inverter/chargers) in a building. This should be fixed:
a) at the origin of the electrical installation;
b) at the metering position, if remote from the origin; and
c) at the consumer unit or distribution board to which the AC supply from the inverter is connected.

Perfect for providing a waterproof seal around cable entry holes into the roof. Two cable glands - one positve, one negative.

Set of four panel corner mounting brackets. Can be used with any aluminium framed solar panel to provide a secure fixing for vehicles, caravans, boats, motorhomes, outbuildings etc. Supports the panel at the optimum height above the surface to enable airflow from underneath, ensuring that it functions to best efficiency.

Fastened to the long sides of the PV panel for extra strength and support. Recommended for larger panels and on vehicles.

Where long cable runs are necessary (e.g. over 20m), labels should be fixed along the d.c. cables.

Circuit protection and all points of isolation should also be labelled with: 'DC Supply - {insert voltage} V DC'

Connectors readily accessible to ordinary persons shall be of the locking type, requiring a tool or two separate actions to separate and shall have sign attached that reads: 'Do not disconnect d.c. plugs and sockets under load'.

Used in systems incorporating energy storage systems (including batteries and inverter/chargers) with grid connected solar photovoltaic systems. To be positioned at the grid supply point and at all points of isolation.

To ensure the Fire and Rescue Service are aware that a PV system is installed on the roof, the following sign shall also be fitted:

Flexible hybrid inverter with powerful emergency power supply.

Used in systems with inverters and diesel generators to warn about the possibility that the generator can start automatically without warning. Small label (100 W x 35 H mm) for use on control panels. Large version (210 W x 65 H mm) for use as a sign on walls/doors etc.

Used in systems with multiple power supplies such as diesel generators, battery/inverter systems and wind or PV systems. To be posted at all points of isolation.

For use between battery and inverter as positive and negative leads. Flexible stranded, rubber double insulated, copper
wire with colour coded solid copper crimped terminal lugs. Terminals have 8 or 10 mm diameter stud mounting holes.
Price per cable.