Collection: Products

These allows gradual adjustment of the angle of inclination and are mounted to the Base Rail Pro. It is completed by adding a Module Support Pro, which can also be clicked into place. 

Designed especially for a safe fastening to corrugated fibre cement or trapezoidal sheet metal roofs on a steel substructure avoiding breakage and leaks.

For flat trapezoidal sheet roofs with less than a 10-degree slope, module installation parallel to the roof is not always optimal, due to low yields and inadequate module self-cleaning.

Useful to quickly align and fit Module Support Pro and Elevation Pro to Base Rail Pro

Designed to provide higher ground clearance for green roofs. FixGrid Pro support plates allow each elevation element to be braced to guarantee stability at heights of up to 35 cm—even in the most extreme conditions.

For placing centrally under under each Base Rail support to protect the roof structure.

Can be fastened between Base Rails to accommodate extra ballast.

Base rail for Schletter FlatGrid and FixGrid 18 systems.

Use the lower FixZ support together with the FixZ centre supports (for the east-west direction) or with the upper FixZ profiles (for the south direction).

Windsafe sheets with integrated ballast tray for theSouth facing applications.Used to provide the necessary ballasting in regions with higher wind loadings.

Sealing plate for use with hanger bolts on sheet metal roofs where fastening to standing seams is not possible.

Flush mounted installations on low-pitch trapezoidal roofs may be less than ideal for self-cleaning and maximum yield. At the same time using conventional struts may not be possible or uneconomical due to higher loads. In these cases FixZ Pro offers flexibility, with a universal and cost-effective solution that optimises load transfer to the roof while providing optional tilt angles as desired.

Used for fastening mounting rails to corrugated roofs. Hanger bolt is screwed through the roof cladding and an adaptor plate bears the mounting rail. A UV-resistant EPDM sealing washer and collar are used to seal the drilled hole.

Accepts Proline module clamps for fastening of modules.

End Caps - one size to suit either 35, 50 or 70 mm mounting rails

Suitable for mounting frameless laminate PV modules to ProLine rail