Collection: Products

Best for irrigation, larger livestock herds and wet land restoration

Extension cables with plugs and sockets used to extend motor cable or cables for dry run protection sensor or tank full float switch.

The Lorentz S1-700 Remote Tank Switch (RTS) allows you to switch off the S1-700 pump when the tank is full. 

The LORENTZ Sun Sensor module and software allow the PS2 controller to accurately estimate irradiation levels and control the pump based on this.

Used to protect Lorentz pump accessories from voltage spikes

Used for dry run protection in applications with LORENTZ Solar Pump Systems. The switch can be used to detect the water level within a well. When the water level in the well drops below the level of the well probe, the LORENTZ Controller will stop the pump and indicate Source Low.

These cables have a male connector on one end and a female connector on the other. They can be used to extend PV module output cables or cut to provide a male & female cable from module to junction box.

Changeover switch to enable Fronius GEN24 full backup functionality.

This 5m extension for Solar iBoost+ allows extension of the cable between the sender and the clamp sensor. This can be useful in properties with thick walls where moving the sender to the other side of a wall will help ensure good signal strength between the Solar iBoost+ and the sender.

The Marlec iBoost Buddy enables remote monitoring and boost control of the Solar iBoost+ immersion controller.

The Marlec Solar iBoost+ automatically diverts excess solar generation (normally exported to the grid) to an immersion heater saving money on water heating costs, reducing use of the boiler and increasing self-consumption of free solar energy.

Mechanical Hexagonal Crimp Tool to suit 25 - 120 sq mm copper tube terminals.

Mechanical Crimp Tool to suit 6-150 sq mm copper tube terminals c/w hexagonal dies and case.

Modular DC Surge Protective Devices (SPD) suitable for a wide range of photovoltaic applications.

MS-MSC Morningstar’s PC MeterBus Adapter converts a controller’s MeterBus RJ-11 to a standard RS-232 serial connector for connection to a PC or other equipment. It may be used with any Morningstar controller or inverter equipped with a meter connection that does not also already have a RS-232 port. Communications link enables monitoring and logging of data as well as customizing of set points.